HOW TO INSTALL PLUG & PLAY RETRO FRAME MOUNT TURN SIGNALS

Step by step guide on how to install the British Customs Rear Turn Signals on a Triumph Bonneville Bobber 

THE INSTALLATION GUIDE APPLIES TO THE FOLLOWING TRIUMPH MOTORCYCLES

• Triumph Bonneville Bobber (2017+)



• Triumph Bonneville Bobber Black (2017+)

TO INSTALL BC PLUG & PLAY TURN SIGNALS YOU MUST HAVE A PAN TAIL LIGHT INSTALLED

INSTALL PLUG & PLAY RETRO FRAME MOUNT TURN SIGNALS

1 - Remove the battery (see How to Remove the Battery)

2 - Remove the (1) fastener & shouldered washer located on the inner part of the frame.

3 - Install the BC Frame Mount Turn Signal with the existing hardware (Removed in Step 2). The Bolt goes through BC Shock Mount Bracket and the Shouldered Washer goes between the Frame Mount BC Shock Mount Bracket.

4 - Route the left BC Frame Mount Turn Signal connector along the frame and into the battery compartment and secure with the adhesive clip and zip tie.

5 - Route the Right BC Frame Mount Turn Signal behind the shock and into the battery compartment and secure with adhesive clip and zip tie. Note: Use a wire to guide the cable into the battery compartment.

6 - Connect the Left & Right Turn Signal Connectors to the BC Sub-Harness.

The right side lead is marked with red heat Shrink.

7 - Install the battery

PLUG & PLAY RETRO FRAME MOUNT TURN SIGNALS INSTALLED ON A TRIUMPH BONNEVILLE BOBBER