How to install Plug & Play Front Turn Signals on Triumph Bonneville Bobber

HOW TO INSTALL PLUG & PLAY FRONT RETRO TURN SIGNALS 


Step by step guide on how to install the plug & play Retro front Turn Signals on a Triumph Bonneville Bobber


THE INSTALLATION GUIDE APPLIES TO THE FOLLOWING TRIUMPH MOTORCYCLES:

  • Triumph Bonneville Bobber (2017+)


  • Triumph Bonneville Bobber Black (2017+)


Triumph Bonneville Bobber Turn Signal Install

HOW TO REMOVE THE TURN SIGNALS


1 - Properly support the vehicle with a stand and/or lift when servicing or performing any work. Unstable vehicles my present dangerous conditions and may cause property damage and/or personal injury


2 - Disconnect and remove the battery 


Triumph Bonneville Bobber Front Turn Signals Install


3 - Remove the gas tank 


4 - Release the (2) fasteners that secure the cable guide on the left-hand side of the frame. Note the routing of the front direction indicator harness for installation.


Triumph Bonneville Bobber Front Turn Signals Install


5 - Disconnect the factory turn signals from the main harness. Located on the headstock of the bike and remove the rubber band securing them to the clutch cable. Note: The routing of the turn signal wires and the position of the rubber band for installation.  


Triumph Bonneville Bobber Front Turn Signals Install


6 - Remove fastener from the left & right factory turn signal mount.